When “Replace Grow Bulbs” light on Control Panel begins blinking
after 6 months of use…
• Unplug AeroGarden PRO
200
.
• Remove old
Grow Bulbs
and carefully discard*.
iMPortant: To avoid burning, be sure
Grow Bulbs
are cool before handling.
• Insert new
Grow Bulbs
into
Lamp Hood
.
• Plug in AeroGarden PRO
200
and press and release “Reset” button to
restart grow bulb timer.
Early grow Bulb Replacement
If you replace
Grow Bulbs
before “Replace Grow Bulbs” light illuminates, be
sure to restart grow bulb timer as follows:
• Press and hold “Lights” button until white light next to your selected plant
type starts blinking – about 5 seconds.
• Release “Lights” button. The plant type selected light will continue to blink
for about 9 seconds. While plant light is still blinking…
• Quickly press and release “Reset” button. “Replace Grow Bulbs” light will
blink once and the plant selected light will stop blinking.
Raise lamp Hood (lights)
As plants grow to
1-2” from lights
, raise
Lamp Arm
one notch at a time (each of the three
Lamp Arm
sections has
three notches). Be sure
Lamp Arm
is set at the lowest setting when you start your AeroGarden PRO
200
.
Unplug AeroGarden PRO
200
and remove
Bowl
from
Base
.
Raise
Lamp Arm/Lamp Hood:
• Hold
Lamp Arm
where it connects to
Lamp Hood
with
one hand. With other hand, push in
Locking Lever.
• Release
Locking Lever
while pulling up on
Lamp Arm.
•
Locking Lever
will automatically click into next
notch in the
Lamp Arm section.
Replace
Bowl
on
Base
and plug in
AeroGarden PRO
200
.
Push locking
lever in
Push locking
lever in
Push locking
lever in
Push locking
lever in
Basic Reminders About Your AeroGarden
(continued)
aerogarden Pro
200
lamp arm & Hood Features
1
2
3
replace grow Bulbs –
order bulbs at www.aerogardensupport.com
12
*Check with local recycling authorities for light
bulb recycling availability in your area.
