Insert snakes 15 into fuselage and secure with epoxy
or CA in holes of rear fuselage formers.
25
From the rear insert carbon tube in fuselage and through hole in rear fuselage former.
The carbon tube should protrude from the former by 5 mm. Align stabilizer horizontally
and glue carbon tube into fuselage.
Secure snakes on top of carbon tube until 5 cm from front edge of stabilizer. Use either
small cut-offs of snake outer 52 or secure snakes with tape.
26
Mark centre line of stabilizer and remove a
4 mm wide strip of covering material. Then
glue in place fin 17, making sure it is
absolutely upright.
27
15
52
17
