SM112001 REV. G
Page 3 of 4
©Woodhead Apr-20
CAUTION:
Do not disassemble balancer without reducing all spring tension first. (See Spring Tension
Adjustment).
Also, do not adjust mainspring tension until tool and attachments are
suspended from balancer. Hazards or unsafe practices COULD result in
minor
personal
injury or product or property damage.
To replace cable, remove balancer from service and remove all
spring tension. (See Spring Tension Adjustment). Remove two
screws at cable guide, four (4) screws and nuts. Remove case
rear assembly, auto stop shaft, auto stop with compression spring,
and cable assembly. Remove cable guide, bumper, cable-stop,
hex nuts, machine screw and tool clip from old cable assembly.
Attach these items to the new cable assembly. Place the swaged
cable assembly end into the slot. Reassemble unit in reverse
order. Place balancer back in service and attach tool. (See Tool
Attachment). Set spring tension. (See Spring Tension Adjustment)
PARTS REPLACEMENT
When ordering replacement parts, always include the balancer model number and serial number.
All parts shown on parts list are replaceable in the field without special tools.
PREVENTATIVE MAINTENANCE
The balancer is designed to require little maintenance. Replace all worn parts immediately. The balancer
is lifetime lubricated at the factory. No additional lubrication is required.
Cable Assembly
Check for wear on hook. More than 10% wear on hook or damage to gate requires replacement.
Check cable-stop and swage fitting next to hook. Cable damage or fraying indicates need for new cable.
Check wears along entire cable length. Drag clean rag along cable. If frayed, replace.
Mounting
Check tightness of mounting bolts and soundness of mounting connection.
Check mounting shackle for wear. More than 10% wear requires replacement.
Check condition of safety cable and attachment points.
Frequency of Inspection:
Depends on intensity and frequency of use. In most cases monthly review of
upper mounting shackle and weekly inspection of cable is adequate.
REPLACEMENT PARTS
