12
EXAMPLE TREATMENT SEQUENCE
Note: The following is a description of a SARS-CoV-2 treatment sequence for a DHC Dash-8-400 aircraft. Operating procedures may require
modification for other viruses, bacteria, aircraft types or variants.
a.
The starting position is at the front of the aircraft, adjacent to the lavatory, with the
lavatory door open. The front of
Aero HygenX RAY – Autonomous UVC Robot
should
be facing the first intended direction of travel.
b.
Place
Aero HygenX RAY – Autonomous UVC Robot
in the starting position and
remove the environmental cover.
c.
Ensure there are no obstructions on the aircraft cabin floor.
d.
Ensure the aircraft cabin has been configured with all tray tables down and all
overhead bins closed.
e.
Plan treatment for either a single or dual pass (loop mode; refer to modes of operation
above)
f.
Turn the Master Power Switch ON. (Power-up is verified by amber flashing lights on
the top of the unit. If the amber lights are not on, ensure both red Emergency Push
Buttons are in the UP position.)
g.
Initiate START sequence by selecting one of the operation modes. (i.e., FORWARD,
REVERSE, or LOOP.)
h.
Exit the aircraft and close the aircraft door within 30 seconds of initiating the START
sequence.
i.
To monitor the progress of
Aero HygenX RAY – Autonomous UVC Robot
, the
operator will be able to see the bright aura of light from outside the aircraft.
j.
For single pass operation, when the first pass is complete, and lamps are
extinguished, enter the aircraft and reconfigure for the second pass by opening the
window shades and placing the meal trays in the UP position.
k.
Initiate the START sequence for the 2
nd
pass.
l.
When the cabin treatment is complete, enter the aircraft, turn the Master Power
Switch off and replace the environmental cover on to the
Aero HygenX RAY –
Autonomous UVC Robot
unit before moving to the next work assignment.
