8
RECEPTION
transport
and
handling
The unit must be handled by qualified personnel.
The unit must be lifted with extreme care to prevent knocks to the frame,
panels, electrical panel, etc.
With the unit you can receive the "crate" accessory for the transport.
NOTE: Plastic elements can be used to protect the units against damage
during transport. The machine is also wrapped in packaging. We
recommend keeping this protection during all transport and lifting
operations and not remove the plastic elements until commissioning.
Inspection upon receipt
Perform the following check upon receipt of the product.
- Check that the exterior has not been damaged in any way.
- Check that the lifting and transport devices are appropriate to the
type of equipment and compliant with the transport and handling
instructions attached to this manual.
- Check that the accessories required for on-site installation have been
delivered and are operational.
- If the unit is provided pre-loaded with refrigerant, make sure there
have been no leaks.
- Check that the equipment supplied corresponds to the order and
delivery note
Product identification
The Aermec products can be identified by the
packaging label
bearing
the identification data of the product and by the
technical plate
bearing
the technical data of your unit.
If the product is damaged, send a registered letter with the details of
the problem to the shipping company within 48 working hours from
delivery.
lifting
The units are delivered on a pallet.
Should you desire to lift using the forklift or pallett jack, we recommend
opening the forks as much as possible to make handling safer.
The width of the forks needs to be adjusted to the pallet openings or in
the unit base.
• Follow all safety regulations and standards
• Wear protective goggles and work gloves
• Pay the utmost attention to heavy and bulky equipment during lifting
and handling, and when placing it on the ground.
• All panels must be tightly fixed before moving the unit;
• Before lifting, check the specific weight on the technical plate.
• Use all, and only, the lifting points indicated.
• Handle the unit with care and without sudden movements.
• Do not stand under the unit during lifting.
• The machine must be kept in a vertical position.
• The units can be stacked (2 max).
Packging label
Technical plate
Motor data plate
Product receipt on pallet wrapped with Estenkol.
Handling possible with forklift in the front/back side and in both
sides. With anti-tip holes.
Handling possible with pallett jack from the front/back side.
Before handling, remove the anti-tip plate following the indications
as the illustration.
