FOR THE INSTALLER
17. SELECTION AND PLACE OF
INSTALLATION
Before installing the unit, decide with
the customer the position in which it will
be placed, pay attention to the follow-
ing points:
−
the support surface must be able to
withstand the weight of the unit;
−
The NXW series are for indoor use
(protection grade IP40) and must
be installed leaving the necessary
technical spaces (see "Minimum
technical spaces"). Observance of
these spaces is to be considered
indispensable in order to allow
normal and extraordinary mainte-
nance operations.
−
The unit must be installed by a
qualified technician in accordance
with the national laws in force in the
country of installation.
18. POSITIONING
The machine is delivered from the fac-
tory wrapped in estincoil.
Before moving the unit, check the lifting
capacity of the machines used.
Once the packaging has been re-
moved, the unit must be handled by
qualified personnel with the suitable
equipment. To transport the machine
use either a forklift or lifting belts (see
figure)
−
The holes in the base to be used for
lifting are indicated with yellow ad-
hesives showing a black arrow. The
blades (not included) which are
adequately scaled must protrude
from the base unit for a sufficient
length so that the lifting straps can
be tautened upwards without them
encountering any interference.
−
Make sure that the straps have
been approved to support the
weight of the unit, be careful that
they a properly fixed to the upper
frame and to the lifting blades, the
safety closure must ensure that the
straps do not work loose of their
housing. The hooking point of the
lifting frame must be on the vertical
of the centre of gravity (see trans-
port figure).
−
In order to avoid damaging the unit
with the cables, insert protection
elements between them and the
machine. It is absolutely forbidden
to stand beneath the unit.
−
Take into account that when the
chiller is working, vibrations may be
generated; it is therefore advisable
to install anti-vibration supports
(AVX accessories), fitting them to
the holes in the base according to
the assembly diagram.
−
Fasten the unit by checking careful-
ly that its on the same level; check
that easy access to the hydraulic
and electric part is allowed.
18.1. MINIMUM TECHNICAL SPACES (mm)
ATTENZION
Use all of the available holes for lifting
The blades not included
1000 mm
1000 mm
1000 mm
1000 mm
fig.1
34
INXWPY. 1004. 4438805_00
Содержание NXW 0500
Страница 2: ......
Страница 54: ...54 INXWPY 1004 4438805_00 ...
Страница 55: ...55 INXWPY 1004 4438805_00 ...