Aeris ATMOS ai, Руководство по эксплуатации

Страница: 79 / 100

79
• Press and release the Advance (Front) button to accept the setting
and advance to DEMO: NI-O2 with CUR (or NEW ) flashing
(Fig. 78).
• When set for NEW , calculations are based on zero residual nitro-
gen and oxygen loading (a clean dive).
• When set for CUR , calculations take into consideration residual
nitrogen and oxygen remaining from previous actual dives.
• Subsequent (repetitive) Simulated dives do not take into consider-
ation previous Simulated dives.
• Press and release the Select (Bottom)) button to toggle between
NEW and CUR .
• Press and release the Advance Front) button to accept the setting
and advance to DEMO: PSI (or bAr ) with OFF, CYL, 3000 psi
(206.5 bar), or 4000 psi (275.5 bar) flashing (Fig. 79).
• When set for OFF , no calculations are made and no displays ap-
pear relating to tank pressure.
• When set for CYL , Air Time Remaining is calculated based upon
actual pressure of the tank that the ATMOS ai is connected to.
• When set for 3000 or 4000 psi (206.5/275.5 bar), Air Time Re-
maining is calculated based upon a simulated tank pressure of that
value.
• Press and release the Select (Bottom) button to advance through
the set points OFF > CYL > 3000 > 4000 (206.5 > 275.5).
• Press and release the Advance (Front) button to accept the setting
and revert to Demo Surface Mode with the DEMO icon flashing.
Fig. 78 - Set Demo Calibration
Fig. 79 - Demo Surface Mode