18 / 34
TF5814GB_E
Aereco S.A.
Description :
·230VAC / 12VDC - 2.5A
·powers the main module
Assembly :
·install one main module per supply
·designed to be mounted on the DIN rail in a power box (width corresponding to
four electrical modules)
This power supply ensures a 12 VDC electrical power supply to the main module. It also enables the filtering of interference on the
secondary module in order to preserve the primary. For this reason, it is essential to connect each module to an individual power supply
(never connect more than one main module to the same power supply).
Performance measurements on starting up the system
Measurement is taken with all the valves open. For this, count up to 10 minutes after the end of the configuration cycle, the cut off the power from the main
module (circuit breaker): the valves will then remain in the open position. Once the measurement is finished, power up the system again.
7.11. MAINTENANCE
The valves do not require any maintenance. Any failures which may occur are reported directly on the main module.
7.12. POWER SUPPLY
VMX Main Module
This supply has been validated for EMC. The use of another power supply is under the responsibility of the installer or specifier.
Aereco declines any responsibility in case of malfunctioning or damage.
MODEL
AVE1227
Input Voltage
110 – 240 VAC
Input voltage range
90 – 264 VAC / 127 – 370 VDC
Frequency range
47 - 63 Hz
Efficiency typical @ 25°C
80 %
85 %
Power factor typical
AC current max.
< 1 A
Inrush current typical
< 40 A with input voltage 230 VAC. (Cold start)
Leakage current
< 0,25 mA
No load dissipation
2,3 – 5,0 W (100 – 264 VAC)
Output Voltage
12 VDC
Rated current
2,5 A
Current range
0 - 1 A
Rated Power Max
30 W
Voltage adjustment range with trimmer
12 – 14 VDC
Voltage accuracy
± 3 %
