29/10/2019
Aeotec Wallmote user guide : Aeotec Group
https://aeotec.freshdesk.com/support/solutions/articles/6000176572-wallmote-user-guide-
5/9
Advanced Functions.
Send a wake up notification.
In order to send your WallMote new configuration commands from your Z-Wave controller or gateway, it will need to be
woken up.
Remove your WallMote unit from its Back Mounting Plate, press and hold the Action Button for 3 seconds (the buzzer
chirp once and the orange LED will be ON) on the back of the WallMote unit and then release it. This will trigger and
send a wake up notification command to your controller/gateway, then your WallMote will wake up for 10 minutes and
the orange LED will fast blink while it is awake (if the WallMote does not receive the Wake Up No More
Info from the primary Controller).
Removing your WallMote from a Z-Wave network.
Your WallMote can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's main
controller/gateway. To do this, please refer to the part of their respective manuals that tell you how to remove devices
from your network.
1.
Put your primary controller into device removal mode.
2.
Unlock your WallMote from the Back Mount plate and take the WallMote unit near to your primary controller.
3.
Press the Action Button on your WallMote.
4.
If your WallMote is successfully removed from the Z-Wave network, the LED will become a colorful gradient for a
few seconds and then turn off. If the removing was unsuccessful, the red LED will be solid for 2 seconds and then turn
off, repeat the above steps.
Including WallMote as a non-secure device:
If you want your WallMote as a non-security device in your Z-wave network, you just need to press the Action Button
once on WallMote when you use a controller/gateway to add/include it.
The green LED will be on for 2 seconds and then the orange LED will fast blink for 10 minutes (if the WallMote does not
receive the Wake Up No More Info command from primary Controller) to indicate the inclusion is successful.
Including WallMote as a secure device:
In order to take full advantage of all functionality the WallMote, you may want your WallMote is a security device that
uses secure/encrypted message to communicate in Z-wave network, so a security enabled controller/gateway is
needed for the WallMote to be used as a security device.
