
Installation and Operation Manual
AENO AP3 air purifier
Document version: 1.0.1, aeno.com
© ASBISc Enterprises PLC. All rights reserved
Page 8 of 39
2.
Place the device on a dry and clean horizontal surface, making sure there is
no chance of it toppling over. Never tilt the device while it is operating.
3.
Do not install the device near open flames, hot surfaces, or heating
appliances. Protect from direct sunlight and other potential heat sources.
4.
Do not use the device in an area where combustible materials such as
hairspray, sprays, deodorants, etc. are sprayed.
5.
Do not use the device in rooms with extreme temperature fluctuations, in a
humid atmosphere, or where it may be exposed to splashing water, dripping
or condensation (for example, over an electric kettle), to avoid fire and/or
electric shock.
6.
Do not place the device in the following locations:
in a draft – near air conditioners, doors, windows, exhaust fans, etc;
over the sink or stove;
in rooms with air temperatures below −20 °C;
in confined spaces (e.g., in a closet or under a closet);
in places where the device can be blocked, e.g., by curtains or furniture.
7.
The device does not remove carbon monoxide or radon. Do not use it to
remove the effects of combustion processes or air pollution by hazardous
chemicals. Do not use the device in an area where the air contains particles
of oil.
8.
The device cannot be used to replace a vent or hood while cooking.
9.
Before connecting the device to the mains, check that the rated voltage
indicated in the technical documentation corresponds to the electrical
voltage of the outlet.
10.
Before turning the device on, make sure that there is no packaging material
on the filter and that the filter is installed according to the instructions.
11.
Connect the device only to a grounded power outlet. Do not use an
extension cord.
12.
Connect the power cord to and from the power outlet only with dry hands.
13.
Place the power cord so that it cannot be accidentally stepped on or
snagged.
14.
Do not place the power cord on anything with a sharp edge and do not place
anything on top of the cord.
15.
Make sure that the power cord does not hang over the edge of furniture or
touch surfaces that could damage the insulation.
16.
Do not wrap the power cord around the device casing.
17.
If the power cord is damaged, first unplug the power outlet, then unplug the
device. The power cable should only be replaced by a service technician.