AEM CD-5, Руководство пользователя

Страница: 43 / 64

43
·
Fastest lap average speed
·
Fastest lap time delta (your current lap compared to the fastest lap)
·
Last lap number
·
Last lap time
·
Last lap average speed
·
Last lap time delta (your current lap compared to the last lap)
·
Current lap number
·
Current lap time
Go to Setup | Lap Timing... Select the GPS button to configure for GPS lap timing. A virtual start/finish line
creation feature allows you to use the beacon input (violet wire in flying lead harness) to set a virtual start/finish line.
While driving the course, press the momentary beacon switch when you cross the start/finish line. Hold for a few
seconds until the left and right LEDs flash. The system captures the location information when you first press the
button. Holding for a few seconds eliminates the likelihood of false triggering the input. You can define your virtual
track width in the dialog window. Set to the approximate width of the track surface plus some extra. The dash
creates a start finish line the width of the Track Width/m setting perpendicular to the heading when the start finish is
set. It then checks whether the previous two points cross this line; the only caveat being that the heading is +/- 90
degrees of the original heading.
The GPS start/finish reference and fastest lap data is saved to non volatile memory in case the vehicle power is
interrupted during operation.
Once your file that contains GPS data is added to an AEMData project, you can add a track map to your project.
Go to
Add | Track and select a spot on your layout.
Click the Setup Track button and choose the GPS tab to configure your track.