3
Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation
instructions and not using the provided hardware may damage the intake tube, throttle body and engine. If you
need any assistance please call1-800-858-3333 to speak with a representative in our Customer Service Center
before returning the product.
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set the parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Do not discard stock components after removal of the factory system.
f. Open the air intake kit package and make sure all parts are included.
2. Removal of stock system
a. Unclip the red locking tab on the mass air flow (MAF)
sensor connector to release the connector from the sen-
sor.
b. Release the MAF sensor wiring harness clips from the
air box.
c. Release the quick-disconnect from the factory air
intake tube. This will require using a thin flathead screw-
driver to reach the clip.
d. Loosen the hose clamp that secures the stock intake
tube to the turbo.
Tools Needed:
Screwdriver
10 & 15mm
Socket
Extension
Socket Driver
Side Cutters
T20 Torx Key
4mm Hex Key
Optional:
Small Torque
Wrench
