3/20/2013
9
10-407
4. Reassemble Vehicle
a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact
any part of the vehicle. Tighten any rubber mounts (if applicable), all bolts, and hose clamps.
b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are
properly tightened.
d. Reconnect the negative battery terminal and start the engine. Let the vehicle idle for 3 minutes. Perform
final inspection before driving the vehicle.
5. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so than an emissions inspector
can see it when the vehicle is required to be tested for emissions. California requires testing every two
years, other states may vary.
6. Service and Maintenance
a.
AEM
®
Induction Systems requires cleaning the intake system’s Dryflow™ air filter element every 100,000
miles. When used in dusty or off-road environments, our filters will require cleaning more often. We recom-
mend that you visually inspect your filter once every 25,000 miles to determine if the screen is still visible.
When the screen is no longer visible some place on the filter element, it is time to clean it. To clean, pur-
chase our Synthetic Air Filter Cleaner, part number 1-1000 and follow the easy instructions.
b. Use window cleaner to clean your powder coated AEM
intake tube.
NOTE: DO NOT USE aluminum
polish on powder coated AEM
intake tubes.
For Technical inquiries
E-mail us at
Or
Call us at
800.992.3000
AEM
Air Intake System Warranty Policy
AEM
warrants that its intake systems will last the life of your vehicle. AEM
will not honor this warranty due to
mechanical damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM
will not
warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent. The powder coating should
only be cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM
intake system is
required for redemption of a warranty claim.
This warranty is limited to the repair or replacement of the AEM
part. In no event shall this warranty exceed the original
purchase price of the AEM
part nor shall AEM
be responsible for special, incidental or consequential damages or cost
incurred due to the failure of this product. Warranty claims to AEM
must be transportation prepaid and accompanied
with dated proof of purchase. This warranty applies only to the original purchaser of product and is nontransferable.
Improper use or installation, use for racing, accident, abuse, unauthorized repairs or alterations voids this warranty.
AEM disclaims any liability for consequential damages due to breach of any written or implied warranty on all products
manufactured by AEM
. Warranty returns will only be accepted by AEM
when accompanied by a valid Return
Merchandise Authorization (RMA) number. Credit for the defective products will be issued pending inspection. Product
must be received by AEM
within 30 days of the date RMA is issued.
If you have a warranty issue, please call (800) 992-3000 and our customer service department will assist you. A proof of
purchase is required for all AEM
warranty claims.
