3
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Turn off the ignition and disconnect the negative battery cable.
e. Do not discard stock components after removal of the factory system.
2. Removal of stock system
Read and understand these instructions BEFORE attempting to install this product. Failure
to follow installation instructions and not using the provided hardware may damage the intake
tube, throttle body and engine.
a. Loosen the hose clamp that secures the stock intake
tube to the intake plenum and then disconnect the
crankcase vent hose from the airbox lid.
b. Unclip the upper airbox retaining clips and remove
the upper airbox and intake tube assembly as shown.
c. Disconnect the vacuum canister hose shown.
d. Using a small screwdriver, release the center holding
pins in the six grill retaining clips shown.
