Warning: Laser Radiation
www.sniper.com.au
OWNERS GUIDE - Model V2 Inox
US Patent 6, 772 524
Make sure the Spindles and Magnetic Vee Block are clean and free of debris before attaching the Snipers.
Fit your Snipers by carefully placing them onto the spindles with the forward arrows facing the front of the kart.
These units will fit any diameter up to 63mm (2 1/2 inch), for non magnetic spindles simply use a cable tie or
similar to attach the units.
The simplest way to get the steering centralized is to place the included steel rule in the centre across the
lower steering shaft bracket and turning the steering shaft until you visually see an equal distance at both
ends of the rule to the tie rods. You may clamp the top steering bush with vice grips or similar, if desired.
Turn your units on and align them to each other by centering the spirit levels, the spirit levels should be
checked occasionally during aligning the kart.
You are now ready to begin adjustment of toe and camber. The laser dot in the center of the grid is the beam
shining out at the opposing unit. Readings are then taken from the unit opposite to the spindle being adjusted.
REMEMBER:
Each line equals 2mm of toe or camber
per side.
Add both sides readings together for the total
alignment setting
Warranty conditions of the country in which the purchase was done, are valid. Keep proof of purchase. Manufactures Warranty is valid for 24
months from month of manufacture.
Caution– Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
The unit should not be exposed to temperatures in excess of 50 degrees Celsius or left in direct sunlight for extended periods.
Damage to the
laser module and spirit level vials may result. To switch on the unit turn the red plastic cap on the back of the unit clockwise until it stops. To turn
the unit off, rotate the cap anti-clockwise one half turn to make sure the cap will not accidentally make contact when not in use.
To replace the battery, turn the cap anti-clockwise until you can remove it from the unit completely. The batteries are CR-1/3N.
No other maintenance is to de done by the user as it may effect the radiation exposure, any other maintenance, service or in the unlikely event that
the units need parts replaced / repaired they must be done by Sniper Precision Technologies.
Do not remove or modify the decals on the units.
This laser product is designated as Class 1 during all procedures of operation.
Wavelength: 650nm, nominal.
Laser Power for Classification: <0.39mW CW.
Beam Diameter: <1.2mm at aperture.
Divergence: <1mRad
Transverse Beam Mode: TEM00
Sniper Precision Technologies V2 Inox
52 Country Drive, Oakford Australia 6121
CLASS1 LASER PRODUCT CLASSIFIED EN/IEC 60825-1 2007
Complies with US FDA performance standards for laser
Products except for deviations pursuant to Laser
Notice No. 50, Dated June, 2007. Manufactured: Month/Year
