AEG SWD81800G0, Руководство пользователя

Страница: 27 / 84

• It is advisable to wait at least four hours before connecting the appliance to allow the oil
to flow back in the compressor.
• Adequate air circulation should be around the appliance, lacking this leads to overheat-
ing. To achieve sufficient ventilation follow the instructions relevant to installation.
• Wherever possible the back of the product should be against a wall to avoid touching or
catching warm parts (compressor, condenser) to prevent possible burn.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the appliance.
• Connect to potable water supply only.
7)
Service
• Any electrical work required to do the servicing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an authorized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses which could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The appliance shall not be discarded together
with the urban refuse and rubbish. The insulation foam contains flammable gases: the ap-
pliance shall be disposed according to the applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchang-
er. The materials used on this appliance marked by the symbol are recyclable.
CONTROL PANEL
1
2 3 4 5 6 7 8
1 Display
2 Bottom Compartment Temperature warmer button
3 Bottom Compartment Temperature colder button
4 Alarm button
5 Light button
6 Top Compartment Temperature warmer button
7 Top Compartment Temperature colder button
8 Appliance ON/OFF button
It is possible to change predefined sound of buttons to a loudly one by pressing together
Light button and Temperature colder button for some seconds. Change is reversible.
7) If a water connection is foreseen.
Control panel 27