AEG LAVATHERM 56740, Руководство пользователя

Страница: 22 / 52

WARNING!
The manufacturer declines any responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be replaced, this must be carried
out by our Service Center.
WARNING!
The plug must be accessible after installing the machine.
Changing door stop
WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
3.
Remove cover plates B . To do this, insert
a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4.
Use an appropriate tool and exert pressure to unfasten locking block C from the snap-
on fixture, take out and re-insert on the other side having rotated the block through
180°.
5. Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite
side and screw down.
6. Re-insert cover plates B on the opposite site having first rotated them through 180°.
7.
Unscrew cover plates D from the front
of the machine, rotate through 180°,
screw on the opposite side.
8.
Unscrew door lock E , push down slightly
and remove from the front of the ma-
chine.
9.
Press snap-in button F in and down,
press cover down slightly and remove from front of the machine.
10. Change door lock E over to the opposite side, screw down the door interlock.
11. On the other side, insert cover F and allow snap-in button to lock into place.
12. Insert loading door and hinges into recesses on the front of the machine and screw
down.
Note regarding contact protection: The machine is only secure for operations again once
all plastic parts have been inserted.
C
B
B
A
A
E
E
D
D
F F
22 Installation