38
Connecting the appliance to the water
supply
Important:
•
This appliance must
not
be connected to the hot water supply.
•
When connecting the appliance, use only new hose kits.
•
Only connect the appliance to the drinking water supply. Rain water
or water for industrial use may only be used if it fulfils the require-
ments of DIN1986 and DIN1988.
•
Do not kink or crush the water inlet hose or drain hose.
Permitted water pressure
The water pressure must be at least 1 bar (=10N/cm
2
=0.1MPa), and
may be a maximum of 10bar (=100N/cm
2
=1MPa).
–
If more than 10bar: Connect a pressure reduction valve.
–
If less than 1bar: Disconnect the appliance end of the inlet hose from
the solenoid inlet valve and remove the flow meter. (In addition re-
move the filter using pointed pliers and take out the rubber gasket
behind it.) Replace the filter.
