AEG IKE64450FB, Руководство пользователя

Страница: 14 / 20

• Use a special scraper for the glass.
6.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,
otherwise, the dirt can cause damage
to the hob. Take care to avoid burns.
Use a special hob scraper on the glass
surface at an acute angle and move
the blade on the surface.
•
Remove when the hob is sufficiently
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration.
Clean the hob with a moist cloth and
a non-abrasive detergent. After
cleaning, wipe the hob dry with a soft
cloth.
•
Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
7.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
7.1
What to do if...
Problem Possible cause Remedy
You cannot activate or oper-
ate the hob. The hob is not connected to
an electrical supply or it is
connected incorrectly. Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
The fuse is blown. Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
You do not set the heat set-
ting for 10 seconds. Activate the hob again and
set the heat setting in less
than 10 seconds.
You touched 2 or more sen-
sor fields at the same time. Touch only one sensor field.
Pause operates. Refer to "Daily use".
There is water or fat stains
on the control panel. Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated. You put something on one
or more sensor fields. Remove the object from the
sensor fields.
The hob deactivates. You put something on the
sensor field
.
Remove the object from the
sensor field.
www.aeg.com 14