AEG FAVORIT 55210, Руководство пользователя

Страница: 22 / 52

Connect the inlet hose to a water tap with an external thread of 3/4”.
If the water inlet hose is too short, replace the water inlet hose with
an applicable, longer high-pressure hose. Do not connect an exten -
sion hose.
To suit the installation, it is possible to turn the end of the hose that
is connected to the dishwasher. Do these steps :
1. Loosen the retaining nut.
2. Turn the hose.
3. Tighten the retaining nut.
WARNING!
Make sure that the retaining nut and all other connections are tight before you move the
dishwasher into position.
WARNING!
Always use a new water inlet hose. Do not use connection hoses from an old appliance.
Drain hose
The appliance has water safety system to prevent water damage. If there is a malfunction,
the drain pump automatically starts to drain the remaining water out of the dishwasher.
WARNING!
Only if the dishwasher is connected to the mains socket, the water safety system operates
when the dishwasher is off.
2 procedures are possible to install the
water drain hose :
1. Attach the plastic curve supplied at
the end of the hose.
Put the water drain hose in the sink.
2. Connect the water drain hose to the
water drain system.
The hose must be less than 75 cm
above the bottom of the dishwasher
to prevent incorrect operation of ap -
pliance.
22 Water connection