60
Themen
Example:
a) The correct setting for DVDs with AC3 sound using a Scart cable for the
picture and sound data (Fig. 2/14).
Front speakers = large
Centre speaker = none
Surround speakers = none
b) The correct setting for DVDs with AC3 sound using the 5.1 audio output
(Fig. 2/8).
Front speakers = small
Centre speaker = small
Surround speakers = small
Subwoofer
None:
The loudspeaker does not produce any audio signals.
Present:
The loudspeaker produces audio signals.
Test Tones
A full surround sound is produced for the test tone. The individual loudspea-
kers are activated one after the other. It is therefore possible for you to check
the connection and settings of your multichannel loudspeakers.
Center/Surround Delay
If you use a 5.1-Audio system, you may experience a distortion of the sound
impression caused by the distance differences between speaker groups and
listener. Sounds that should be heard by the listener at the same time arrive
successively.
Here you can delay the sounds from the central and rear loudspeakers in order
to produce a balanced sound for the listener.
Digital Output
Here you specify the settings for the digital Audio output.
Off:
No digital audio signal is produced.
PCM:
Output of a digital Audio signal that is converted to a 2-channel
signal. Use this setting if your amplifi er is a two-channel stereo amplifi er.
RAW:
Output of a digital Audio signal. Use this setting if your amplifi er is
no two-channel stereo amplifi er.
NOTE:
If there is no Audio output, even though you connected the DVD-Player to an
amplifi er, you will most likely have chosen an incorrect setting for the Audio
output.
Changing the default settings
05-DVD 4525 AEG - GB 60
24.04.2007, 15:42:05 Uhr
