AEG CS 66, Инструкция по эксплуатации

Страница: 8 / 12

8
SWITCH (FIG. 10)
The tool is started and stopped by squeezing and releasing the
trigger switch. To prevent the tool from being started acciden-
tally, the trigger can only be operated if the safety button is
depressed first. The safety button can be depressed with the
thumb leaving the fingers free to squeeze the trigger switch. It
is not necessary to maintain pressure on the safety button once
the trigger switch has been moved from its starting position.
OPERATION (FIG. 11)
DANGER: Keep hands away from the cutting area.
When operataing the tool keep the cord away from
the cutting area and position it so that it will not be
caught on the work piece during the cutting operation.
It is important to saw with steady and even pressure ( DO NOT
FORCE) in order to obtain a uniform cut. Cut at a speed suited
to the work piece. (Work slowly when timber is hard.)
Inspect the saw blade frequently and replace or sharpen if dull,
to avoid overloading the motor.
CUTTING POSITION (FIG. 12 A, 12 B)
Cutting the work piece at 0°, use point “A” of the base plate
line guide and move the saw along the line to be cut. Cutting
at 45°, use point “B”.
This line guide shows an approximate line of cut.
Make a sample cut in scrap timber to verify the actual line of
cut.
CAUTION: The saw guide fence should only touch
the work piece slightly and should not be forced.