74
• If the cupboard is deeper than 300 mm, cover the gap between the
hood and the wall with a finishing strip (special accessory).
To install it, proceed as follows:
Measure the wall distance and apply the covenng strip over the
necessary width (wall distance plus 5 to 8 mm), kinking the covering
strip at the appropriate notches and tearing off the surplus material
(removing the protective foil).
Then fasten the strip to the bottom part of the hood with three clips
(special accessories). Apply pressure.
Fig. 12
.
Fitting the charcoal filter for recirculation version
If the extractor hood is installed as a return air appliance (Recirculation
version - air outlet above the wall unit), the charcoal filter (available from
your local Service Force Centre) must be fitted before the grease filters
are fitted.
Installation sequence:
1. Insert the holding frame for the charcoal filter in the shaft of the hood
with the 2 lugs facing upwards and then clip into the lower holes.
2. Fix the holding frame on the lower part of the housing of the hood
with the 2 screws supplied.
Fig. 13
.
3. Fit the charcoal filter (see paragraph “Charcoal filter”)
4. Refit the grease filters. Push-in the visor.
Fig. 12
Fig. 13
