English
45
Mounting holes
WIRING REQUIREMENTS
The cooker MUST be installed in compliance
with:
• Wiring connections in AS/NZS 3000 Wiring
Rules.
• Local regulations, municipal building codes
and other statutory regulations.
For New Zealand Only:
The cooking range must be connected to
the supply by a supply cord fitted with the
appropriately rated plug. This plug is to be
compatible with the socket-outlet fitted to the final
sub-circuit in the fixed wiring that is intended to
supply this cooking range.
Supply cord size required
BPK75891PT - 4mm2
Data plate
gives information about
rating is located behind
the bottom of the oven
door
•
Disconnection in the fixed wiring must
occur in accordance with the AS/NZS3000
wiring rule.
• The cooker requires a means of all pole
disconnection incorporated into the fixed
wiring. This MUST have a disconnection
gap of 3mm.
• The cooker MUST be properly earthed.
• This oven must be connected with cable
of 75°C rating minimum.
• This product has passed the insulation
resistance test after manufacture. If the
resistance reading is low at installation,
it is probably caused by moisture from
the atmosphere being absorbed by
the elements after the range has been
produced. (Pass at 0.01 MW AS/NZS
3000 Wiring Rules Clause 8.3.6.2).
NOTE: When connections are made to a
multi-phase 230/240V supply, the bridge
piece MUST be removed from between the
active connections.
Rated Power Input
Model
Total kW
BPK75891PT
5.2
IMPORTANT!
Before you cook in your new oven
it is important
that the protective oils used
in the manufacture of the product
be removed.
• Make sure that the room is well ventilated
(to allow smoke to escape).
• Run the grill on high for 15 minutes without
grill dish.
• Then run the oven on 180°C for 30 mins.
Connecting to services and
commissioning
This appliance must be installed by an
authorised person, according to all codes
and regulations of:
• Electrical supply authorities.
• Building regulations.
• Local government and council authorities.
• AS/NZS 3000 (particular attention to clause
4.3.11 and clause 3.9).
Hard wiring detail
1. Remove terminal cover plate from rear
panel of appliance.
2. Fit wires through hole in cover plate and
make connections to terminals.
3. Engage wires into plastic clip. Secure
plastic clip with two long silver screws
(supplied in separate bag).
4. Replace cover plate onto rear panel.
Содержание BPK75891PT
Страница 1: ...USER MANUAL EN User Manual Oven BPK75891PT ...
Страница 50: ...www aegaustralia com au www aegnewzealand co nz 50 NOTES ...
Страница 51: ...English 51 NOTES ...
Страница 52: ...www aegaustralia com au www aegnewzealand co nz 52 NOTES ...