Problem
Possible cause
Solution
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to the "Operation" chap‐
ter.
The room temperature is
too high.
Refer to the "Installation"
chapter.
The door is opened too of‐
ten.
Do not keep the door open
longer than necessary.
The door is not closed cor‐
rectly.
Refer to the "Closing the door"
section.
The light does not work.
The appliance is not plug‐
ged in.
Connect the appliance.
The circuit breaker tripped
or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective.
Contact the service.
The light button is not op‐
erating.
Contact the service.
Too much vibration.
The appliance is not sup‐
ported properly.
Check if the appliance stands
stable.
The appliance is noisy.
The appliance is not sup‐
ported properly.
Check if the appliance stands
stable.
Water flows on the rear plate
of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the wine
cabinet.
Products prevent that wa‐
ter flows into the water col‐
lector.
Make sure that products do
not touch the rear plate.
The temperature in the wine
cabinet is too low or too
high.
The temperature regulator
is not set correctly.
Set a higher or lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to the "Closing the door"
section.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
9.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
9.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH
57