AEG AVC-1530-G, Инструкция по эксплуатации

Страница: 9 / 16

WARNING! BE SURE TO READ, UNDERSTAND
ALL WARNINGS AND INSTRUCTIONS IN THE
MANUAL BEFORE USE. DO NOT VACUUM IN
AREAS WITH FLAMMABLE GASES, VAPORS,
OR EXPLOSIVE DUSTS IN THE AIR.
Flammable gases or vapors include but are not
limited to;
Lighter fluid, solvent type cleaners, oil-base paints,
gasoline, alcohol or aerosol sprays. Explosive
dusts include but are not limited to;
Coal, magnesium, grain or gun powder. To reduce
the risk of health hazards from vapors or dust, do
not vacuum toxic materials.
WARNING! Make sure plug is disconnected before
assembling the wet/dry vac.
WARNING! If filters are contaminated or damaged,
they must be replaced prior to performing wet
vacuuming operations.
REMEMBER! The foam filter must be removed after wet
vacuuming, and the HEPA filter must be reinstalled before dry
vacuuming again.
1. Verify that the power cord is disconnected from the mains
power source. Verify that the tank is clean and free of dust
and dirt.
2. Remove all dry vacuum use filters.
3. Rinse out the inside of tank to remove any loose debris.
4. Then carefully install the foam sleeve filter over the filter
cage and place the power head back on the tank. (Fig. 23)
1. Fit the desired nozzle to the vacuum hose. (Fig. 24)
2. Verify that the switch is in the ‘O’ OFF position before
plugging the power cord into the mains power source.
3. Turn the motor on by flipping the switch to the ‘I’ ON
position. (Fig. 25)
4. After use, empty the tank by unscrewing the drain cap.
Drain liquids into a suitable receptacle or drain. Remember
to refit the drain cap to the tank after draining tank. (Fig. 26)
CONNECT THE MAINS PLUG.
WET VACUUMING
DO NOT USE THE HEPA FILTER FOR WET VACUUMING
OPERATING INSTRUCTIONS – WET VACUUMING
Leave a gap at the tip of the nozzle opening to allow air inflow.
The machine is fitted with a float valve that stops the suction
action when the tank reaches its maximum capacity. You will
notice an increase in motor speed.
When this happens, turn off the machine, disconnect from
power supply, and drain the liquid into a suitable receptacle or
drain. To continue vacuuming, refit the tank with the drain
cap. After wet vacuuming, turn the machine off and remove
plug from power supply. Empty the tank, clean and dry the
inside and outside before storage.
IMPORTANT! When vacuuming large quantities of liquids, do
not immerse the nozzle completely in the liquid;
7
WET VACUUM OPERATION
Fig. 23
Fig. 22 Fig. 21
Fig. 24
Fig. 25 Fig. 26
1. Switching on the vacuum cleaner: Press
2. Connecting electrical appliances: Press
Connect the plug of electrical appliance with Power Take Off
socket outlet on the Shopvac (Fig. 21). Flipping the switch
to the ‘II’ position (Fig. 22).
Only connect electrical appliances with a maximum power
rating of 900W. Switching on the electrical appliance
automatically switches on the vacuum cleaner. Once the
electrical appliance has been switched off, the vacuum
cleaner switches off following a time lapse.
3. Switching off the vacuum cleaner: Press
I
O
II