AEG ABB66011AS, Руководство пользователя

Страница: 27 / 64

Problem Possible cause Solution
Appliance is fully loaded
and it is set to the lowest
temperature Set a higher temperature. Re-
fer to "Operation".
Temperature set in the ap-
pliance is too low and the
ambient temperature is
too high. Set a higher temperature. Re-
fer to "Operation"
Temperature is set incor-
rectly. Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC", or after changing the
temperature. This is normal, no error has
occurred. The compressor starts after a
period of time.
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The food products' tem-
perature is too high. Let the food products temper-
ature decrease to room tem-
perature before storage.
The thickness of the frost is
greater than 4-5 mm. Defrost the appliance.
The door has been
opened often. Open the door only if necessa-
ry.
The "FROSTMATIC func-
tion" is switched on. Refer to "FROSTMATIC func-
tion".
There is no cold air circula-
tion in the appliance. Make sure that there is cold air
circulation in the appliance.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9.
NOISES
There are some sounds during normal running (compressor, refrigerant circulation).
ENGLISH 27