AEG 916099337, Руководство пользователя

Страница: 24 / 36

Error code Possible cause Remedy
EH0
The mains supply is unstable. When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
11.2 Troubleshooting
Problem Possible cause Remedy
The tumble dry‐
er does not op‐
erate.
The tumble dryer is not connected
to the mains supply.
Connect it to the mains socket.
Check the fuse in the fuse box (do‐
mestic installation).
The door is open. Close the door.
The On/Off button was not pushed. Push the On/Off button.
The Inicio/Pausa button was not
touched.
Touch the Inicio/Pausa button.
The appliance is in standby mode. Push the On/Off button.
Unsatisfactory
drying result.
Incorrect program selection.
Select a suitable program.
1)
The filter is clogged.
Clean the filter.
2)
Nivel de Sec. option was set to
seco plancha/engomar .
3)
Change Nivel de Sec. option to a
higher level.
The load was too large. Do not exceed the maximum load
size.
The airflow slots are clogged. Clean the airflow slots at the bot‐
tom of the appliance.
There is some dirt on the humidity
sensor in the drum.
Clean the front surface of the
drum.
The dryness level was not set to
the desired level.
Adjust the dryness level.
4)
The condenser is clogged.
Clean the condenser.
2)
www.aeg.com 24