AEG 62 D4A 01 CA, Руководство пользователя

Страница: 26 / 32

Problem Possible cause Remedy
The display does not react to the
touch.
Part of the display is covered or the
pots are placed too near to the dis‐
play.
There is some liquid or an object on
the display.
Remove the objects. Move the pots
away from the display.
Clean the display, wait until the ap‐
pliance is cold. Disconnect the hob
from the electrical supply. After 1
min, connect the hob again.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
You put something on one or more
sensor fields.
Remove the object from the sensor
fields.
The hob deactivates. You put something on the sensor
field
.
Remove the object from the sensor
field.
Residual heat indicator does not
come on.
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor under the hob surface is dam‐
aged.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
After you activate Assisted Cooking,
the hob starts heating up, stops, and
then starts again.
This is a safety check to ensure that
the Food Sensor is in a pot for
which Assisted Cooking function
was activated.
It is a normal procedure, it does not
indicate any malfunction.
You cannot activate the highest heat
setting.
Another zone is already set to the
highest heat setting.
First reduce the power of the other
zone.
The sensor fields become hot. The cookware is too large or you put
it too near to the controls.
Put large cookware on the rear
zones, if possible.
The display shows that the Food
Sensor is not found.
The position of the Food Sensor is
incorrect.
Something blocks its signal (e.g.
cutlery, a pan handle or another
pot).
Position the Food Sensor correctly.
Refer to "Hints and tips".
Remove any metal objects or other
objects that may block the signal.
The display shows the temperature
of water is higher than 100°C.
You did not calibrate the Food Sen‐
sor or you did it incorrectly.
You moved the hob to a different lo‐
cation.
Calibrate the Food Sensor again.
Refer to "Calibrating".
You may also need to check if the
calibration code is correct. Refer to
"Pairing".
You put too much salt in the water. Do not salt boiling water.
Temperature is not visible on the
display.
The display shows a warning icon.
The Food Sensor did not establish
connection with the hob because
the strength of the signal is too low.
Place the Food Sensor close to the
antenna on the hob surface, near
the centre of the hob. Refer to "Hints
and tips".
Something covers the Food Sensor
or the antenna on the hob surface,
e.g. a piece of metal cutlery.
Remove anything that covers the
antenna. Make sure you place cook‐
ware in the centre of the cooking
zone. Refer to "Hints and tips".
The connection between the Food
Sensor and the antenna was lost.
Make sure nothing covers the sig‐
nal. Move the Food Sensor along
the rim of the pot to adjust its posi‐
tion. Refer to "Hints and tips".
26 ENGLISH