13
13
Keep firm footing and balance. Do not overreach. Overreaching can
result in loss of balance or exposure to hot surfaces.
Before starting the product, make sure the cutting blades will not
come in contact with anything.
While operating the hedge trimmer, always hold it firmly with both
hands by the two handles. Ensure that the operating position is
safe and secure. The manufacturer does not recommend the use
of steps or ladders. If higher trimming is required, use an extended-
reach tool.
Blades are sharp. When handling the blade assembly, wear non-
slip, heavy duty protective gloves. Do not place your hand or fingers
between blades or in any position where they could get pinched
or cut. Never touch the blade nor service the product unless the
battery pack is removed.
Switch off and remove the battery pack before:
■
adjusting the working position of the cutting means
■
cleaning or clearing a blockage
■
leaving the product unattended
■
checking, conducting maintenance, or working on the product
Do not force the product through heavy shrubbery. This can cause
the blades to bind and slow down. If the blades slow down, reduce
the pace.
Do not attempt to cut stems or twigs that are larger than 28 mm, or
those obviously too large to feed into the cutting blade. Use a non-
powered hand saw or pruning saw to trim large stems.
Use of hearing protection reduces the ability to hear warnings
(shouts or alarms). The operator must pay extra attention to what is
going on in the working area.
WARNING! If the product is dropped, suffers heavy impact,
or begins to vibrate abnormally, immediately stop the product
and inspect for damage or identify the cause of the vibration.
Any damage should be properly repaired or replaced by an
authorised service centre.
TRANSPORTATION AND STORAGE
Stop the product, remove the battery, and allow it to cool before
storing or transporting.
Clean all foreign materials from the product. Store the product in a
cool, dry, and well-ventilated place that is inaccessible to children.
Keep away from corrosive agents, such as garden chemicals and
de-icing salts. Do not store outdoors.
For transportation in vehicles, secure the product against movement
or falling to prevent injury to persons or damage to the product.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling when
transporting batteries by a third party. Ensure that no batteries can
come in contact with other batteries or conductive materials while
in transport by protecting exposed connectors with insulating, non-
conductive caps or tape. Do not transport batteries that are cracked
or leaking. Check with the forwarding company for further advice.
MAINTENANCE
WARNING!
Use only original manufacturer’s replacement
parts, accessories, and attachments.
Failure to do so can cause
possible injury and poor performance, and may void your warranty.
WARNING! Servicing requires extreme care and knowledge
and should be performed only by a qualified service technician.
For service, bring the product to an authorised service centre. When
servicing, use only identical replacement parts.
WARNING! The blades are extremely sharp.
To prevent
personal injury, exercise extreme caution when cleaning, lubricating
and fitting or removing the blade protector.
Remove the battery before adjusting, maintaining, or cleaning the
product.
You may make adjustments and repairs described in the manual.
For other repairs, contact the authorised service agent.
After each use, clean the body and handles of the product with a
soft, dry cloth.
After each use, clean the debris from the blades with a stiff brush,
and then carefully apply a rust preventative lubricant before refitting
the blade protector. The manufacturer recommends you to use a
rust preventative and lubricant spray to apply an even distribution
and reduce the risk of personal injury from contact with the blades.
For information about suitable spray product check with your local
authorised service centre.
You may wish to lubricate the blades lightly before use if necessary
using the above method.
Check all nuts, bolts, and screws at frequent intervals for proper
tightness to ensure the product is in safe working condition. Any
part that is damaged should be properly repaired or replaced by an
authorised service centre.
RESIDUAL RISKS
Even when the product is used as prescribed, it is still impossible
to completely eliminate certain residual risk factors. The following
hazards may arise in use and the operator should pay special
attention to avoid the following:
■
Injury caused by contact with the blades. Contact with the
blades can cause serious injury. Keep the blade away from
yourself and others. Cover it with the blade protector whenever
you are not cutting.
■
Injury caused by vibration. Always use the right tool for the job,
use designated handles and restrict working time and exposure.
■
Hearing injury caused by exposure to noise. Wear ear protection
and limit exposure.
RISK REDUCTION
It has been reported that vibrations from handheld tools may
contribute to a condition called Raynaud’s Syndrome. Symptoms
may include tingling, numbness, and blanching of the fingers,
usually apparent upon exposure to cold. Hereditary factors,
exposure to cold and dampness, diet, smoking and work practices
are all thought to contribute to the development of the these
symptoms. There are measures that can be taken by the operator
to possibly reduce the effects of vibration:
■
Keep your body warm in cold weather. When operating the unit
wear gloves to keep the hands and wrists warm.
■
After each period of operation, exercise to increase blood
circulation.
■
Take frequent work breaks. Limit the amount of exposure per
day.
■
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor.
WARNING! Injuries may be caused, or aggravated, by
prolonged use of the product.
When using any tool for prolonged
periods, ensure you take regular breaks
SYMBOLS
Safety alert
Please read the instructions carefully before
starting the product.
Wear ear protection.
Wear eye protection.
Do not expose to rain or damp condition.
Always hold the hedge trimmer with both hands
when operating.
Wear non-slip, heavy duty gloves.
Remove the battery pack before starting any work
on the product.
Beware of thrown or flying objects. Keep all
bystanders, especially children and pets, at least
15m away from the operating area.
To prevent serious injury, do not touch cutting
blades.
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authority or
retailer for recycling advice.
The following signal words and meanings are intended to explain
the levels of risk associated with this product.
DANGER
Indicates an imminently hazardous situation, which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation, which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation, which, if not
avoided, may result in minor or moderate injury.
CAUTION
Without safety alert symbol
Indicates a situation that may result in property damage.
Содержание 3381007
