12
Location
Fig. 1
This appliance is
d e s i g n e d t o b e
built-in to a space
having the dimen-
s i o n s g i v e n i n
Fig. 1.
Fig. 2
The height of the
appliance can be
altered if required
by means of ad-
justable feet situat-
e d a t i t s b a s e
(Fig. 2).
Door reversibility
Remove the two screws which fix the upper hinge to
the door.
Fig. 3
Carefully lean the
a p p l i a n c e o n i t s
back and remove
the plastic insert
(Fig. 3).
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge to
the base of the appliance and remove the hinge itself;
be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to the
appliance and remove the hinge itself.
100-170
596
820-870
547
550
600
820
870
D506
D507
D447
Fig. 4
Take the hinge re-
m o v e d f ro m t h e
upper part of the
appliance on the
opposite side (see
Fig. 4), and, using
t h e s c re w s r e -
m o v e d f ro m t h e
lower part, fix it to
the base of the ap-
pliance itself.
Remove and refit the other hinge on the upper part of
the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges (Fig. 4).
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and fit
the insert supplied with the appliance on the opposite
side.
Fitting a decorative door panel
Important: The components needed to fit the dec-
orative panel have been pre-fitted on the appli-
ance.
The brackets are secured to the panel by means of
the 7 Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the large
top bracket by unscrewing the screws and adjust-
ing pins pre-fitted on the appliance door. The small
bottom bracket need not be removed.
Fig. 5
P l a c e t h e a p p l i -
ance in the posi-
tion where it is to
be built in (Fig. 5).
The appliance is fit-
ted with adjustable
feet; screw the front
and rear feet in or
out to adjust the
height of the appli-
ance to that of the
recess.
Keeping the appliance central in the recess, slide it in
until its back touches the wall.
With a tape measure (or similar instrument), measure
distance (A) between the top edge of the door and the
top edge of the decorative panel, placing it next to the
recess.
D510
D467
=
=
A
