aee.com
18
3. Prepare the Propellers and Propeller Guard Rings
Condor uses 10.5 inch propellers, whose caps are marked or unmarked with “P”. Propeller is a consumable.
Purchase new propellers when necessary.
3.1 Introduction for Propellers
Propeller
With “P”-unmarked Cap (1045)
With “P”-marked Cap (1045P)
Sketch
Installation position
Install onto the motor shafts of
the arms unmarked with “P”
Install onto the motor shafts of
the arms marked with “P”
Direction marks
Tighten: install the propeller onto the motor in this direction.
3.2 Install the Propellers
As shown in Fig. 13, prepare two propellers with “P”-marked cap and two propellers with “P”-unmarked cap
and install them respectively onto the motor shafts of the arms marked with “P” and the motor shafts of the
arms unmarked with “P”. Tighten the propellers in the tighten mark direction.
Fig. 13
(1) Tighten the self-propelled propellers rather than use any screw glue..
(2) Make sure all propellers are installed in their places. Improper installation may cause the UAV to
work improperly. To protect the thin blades against scratches, please wear gloves while installing the
propellers.
3.3 Remove the Propellers
:UHQFK
7XUQLQJ'LUHFWLRQ
Fig. 14
To remove the propeller, hold the motor with the
wrench or by your hand and turn the propeller in
the direction opposite to the mark.
