AE Techron LVC 5050, Быстрый старт

Страница: 22 / 24

Connecting Power
The
LVC 5050 uses a 3-wire (grounded) AC line system. At times, the
third wire ground may introduce a ground loop into the system.
Each
LVC 5050 is supplied from the factory with an appropriate AC
cord.

Units set up for 100 to 120 VAC operation is shipped with 10
AWG, 30 amp line cords.

Units set up for 200 to 240 VAC operation is shipped with 12
AWG, 20 amp line cords.

North American units set up for 120 VAC, 60 Hz operation
are provided with a 125 volt, 30 amp NEMA TT30P plug.

Units destined for other parts of the world are provided
without a plug.
Whenever possible, connect the power cord to an isolated power
circuit with adequate current . Excessive line voltages of more than
11% above the amplifier's rated line voltage will activate the
overvoltage protection circuitry.
All specifications in this manual were measured using 120 VAC, 60
Hz power mains unless otherwise noted. Specifications are derived
using a peak main voltage equal to the true peak of a 120 V RMS sine
wave with all available channels fully loaded.
Although this amplifier is rated for operation at 100 and 120 VAC, it is
more efficient at 200, 208, 230 or 240 VAC. At these higher voltages,
less power is converted to thermal energy in the AC cord and slightly
more power is available at low frequencies.
Page 22