Adventurer LP Eagle Cap, Руководство пользователя

Страница: 26 / 39

T
RUCK
C
AMPER
O
WNER
’
S
M
ANUAL
© ALP (Adventurer Limited Partnership). 22 All Rights Reserved
WARNING: This procedure should be used in an
emergency only. Dealer service will be required to
re-set slide to normal operation.
Slide-Out Manual Operation (Schwintek slides)
1. Electronic Manual Override (available on board revision C1and newer):
A. Locate the circuit board.
B.
Press the “mode button” six times quickly, then
press a seventh time and hold for approximately five
seconds.
C. The red and green LED lights will begin to flash,
confirming the override mode.
D. Release mode button.
E. Back inside camper; use the normal slide control
switch to retract the room.
2. Manually Push Room in Override:
A. Locate the circuit board.
B. Unplug both motors from circuit board (releases
motor brake).
C. Push or pull slide room in as desired; larger rooms
may require several people to push.
D. Keep both sides of room relatively even.
E. When room is completely in, plug both motors back
into the control board (this applies the brake for
road travel).
3. Disengage Motors, Manually Retract Room and Travel Lock:
A. Bend back wipe seal & visually locate motor, near the top of each vertical column.
B. Locate and remove motor retention screw located
C.
Pull the motor up until disengaged, about ½ ”.
Replace the motor retention screw to hold the motor
in this position.
D. Repeat this process for both sides of the slide room.
E. Push or pull room back in to the opening, keeping
sides relatively even.
F. Re-engage motor to be ready for travel.
G. The room must be travel locked to keep room in
place for road travel.
Additional information with photos is on line at:
www.AMLRV.com
(under
manuals).