AdvenChair Field Guide
Page 7
3.
Setting up a fully disassembled AdvenChair
a.
Unfold the seatback
by pulling the top of the seatback up and back until it is upright.
b.
Install the handlebars
i.
Pull the detent pins from the lower steering tubes.
ii.
Lift the handle bars and slide the attached steering tubes into the lower steering
tubes.
iii.
Insert the detent pins into each steering tube to position the handle bars at the
desired height.
c.
Install the main wheels
i.
Tip the chair onto its front.
ii.
Place each wheel in position with the brake rotor in the brake caliper slot (Figure
4) and the wheel hubs in their dropouts (Figure 5). Make sure to slide the brake
rotor straight into the brake caliper slot to avoid damaging the rotor and the brake
pad.
iii.
Slide the axle through the axle dropouts and the hub; screw the axle tight with a
6mm hex wrench.
d.
Lower the casters
i.
Tip the chair on its back.
ii.
Pull the yellow pins from each caster, rotate each caster down and pin them in
place (Figure 3).
e.
Position the footrest
i.
Tip the chair upright, on its wheels and casters.
ii.
Unpin the footrest assembly by pulling the red pins and the footrest tray by pulling
the blue pins.
iii.
Rotate the footrest assembly down and pin both sides with the red pins in the
desired position. There are three holes, for different angles.
iv.
Position the footrest tray in the desired position and pin both sides with the blue
pins.
