AdvenChair Field Guide
Page 15
11.
Installation and Adjustment of the Headrest
(optional component): (Figure 11)
a.
The bracket can be lowered 3” by removing the four screws with a 5mm hex key and
reattaching the bracket to the four holes below the current bracket position. This will
position the headrest for a short person.
b.
Install the headrest:
Slide the stem of the headrest support into the headrest bracket
and tighten the clamp. The height is adjusted by how far the stem is inserted into the
bracket. The bottom of the stem must be in far enough for the clamp to engage with
the stem.
c.
Adjust the angle of the headrest:
There are two swivel joints on the headrest support.
Loosen both of them with a 5mm hex wrench just enough so they can be moved. Adjust
the height and angle of the headrest, and tighten the swivel joints.
Figure 11. Installing and adjusting optional headrest.
