TREK-775/TREK-776 User Manual
28
Chapter 4
Jumper Settings and Connectors
4.1 Setting Jumpers
The Vehicle Mounted Computer can be configured to match the needs of
each application by setting the jumpers. A jumper is the simplest kind of
electrical switch. It consists of two metal pins and a small metal clip
(often protected by a plastic cover), which slides over the pins to close the
circuit and connect them. To “close” a jumper, connect the pins with the
clip. To “open” a jumper, remove the clip. Sometimes a jumper has three
pins, labeled 1, 2, and 3. In this case, it is possible to connect either pins 1
and 2 or pins 2 and 3 to each other.
A pair of needle-nose pliers may be helpful when working with jumpers.
If there are any doubts about the best hardware configuration for a partic-
ular application, contact the local distributor or sales representative
before making any changes.
An arrow is printed on the motherboard to indicate the first pin of each
jumper.
Open
Closed
Closed 2 - 3
Open
Closed
Closed 2 - 3
Содержание TREK-775
