Advantech RSB-4410, Руководство пользователя

Страница: 14 / 66

RSB-4410 User Manual 6
2.1 Jumpers
2.1.1 Jumper Description
Cards can configured by setting jumpers. A jumper is a metal bridge used to close an
electric circuit. It consists of two metal pins and a small metal clip (often protected by
a plastic cover) that slides over the pins to connect them. To close a jumper, you con-
nect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1,2 and 3. In this case you would connect either
pins 1 and 2 or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
2.1.2 Jumper List
Warning! To avoid damaging the computer, always turn off the power supply
before setting jumpers.
1 2 1 2
Table 2.1: Jumper List
J1 Boot device
J2 LVDS Power
J3 Backlight Power