Advantech MIC-3056, Руководство пользователя

Страница: 15 / 36

MIC-3056 User Manual -- Page 9
getting pinched.
3. Insert the card into the chassis by sliding the both edges of the card into the card
guides.
4. Push the card into the slot gently by sliding the card along the card guide rails
until the handles meet the rectangular holes of the handle locker rails.
Note: If the card is correctly positioned and has been slide all the way into the
chassis, the handles should match the rectangular holes. If not, remove the card
from the card guide and repeat step 3 again. Do not try to install a card by forcing
it into the chassis.
5. Left-pull the right handle and right-pull the left handle to push the card into place.
6. Secure the card by locking the handles into place.
Figure 2-3: Installing a card into the chassis
To remove a card:
1. Release the locking latches on the handles.
2. Push the both handles out to release the card from the backplane.
3. Slide the card out.
2.3.2 Before Operating the System.
Before operating your system, first check your power supply source.
The power supply module included in the MIC-3056 chassis accepts a full input
range of 100~240 V
AC
without any switch setting.
Two mounting flanges are included for users who would like to install the MIC-3056
on a 19" rack.