4 ASR-3100 Startup Manual
/ASR-3100快速入门手册/ASR-3100快速入門手冊
2. Mount the chassis (inner) member to the chassis.
You may opt for the M4 or M5 pan head screw. The
screw head of either M4 or M5 can not exceed 2.0 mm.
Alternatively, you may mount the slide member to the
chassis through standoffs. Likewise, the head of stand-
off can not exceed 2.0 mm. Each side of chassis needs
to use 3 screws or standoffs for slide attachment.
3. Attach the cabinet (outer) member to the rail.
Insert the stag into the upper and lower square holes
on EIA rail from the back of rail. Push the safety lock
forward to secure the bracket. It is important to check if
the safety lock is in the unlocked position before mount-
ing the brackets.
4. Mount the chassis into the cabinet.
Insert the chassis (inner) member into the cabinet
member as shown on the drawing. It is important to
check if the ball retainer is in fully open position before
installing the chassis, otherwise it might cause cata-
strophic damage to the chassis if the ball retainer is not
in the fully open position while mounting the chassis.
While you are pushing the chassis back to the cabinet,
you need to release the slide from its locking position by
pressing the trigger down.
Cable Management Arm (CMA) Installation
1. Attach the inner member connector to the rear of the
right hand inner slide member, and supporting bar con-
nector to the rear of the right hand middle slide member
as shown on the illustration.
2. Attach the supporting bar connector to the rear of left
middle member, and the outer member connector
to the rear of the left outer member as shown on the
illustration.
3. Open the red cap as shown, and routing the cable and
cords through the wire carrier. Very important!!
Use Velcro strap to fasten the cables and cords. You
may find slot on connectors and aluminum joints. Use 2
straps on each joint and 1 on each connector.
Move the chassis back and forth to see if cable arm motion
is smooth. If not, loosen the strap a little bit for better motion.
System Setup
/系统安装/系統安裝
