Advantech ADAM-5510/P31, Руководство пользователя

Страница: 185 / 202

ADAM-5510/P31 F-5
Appendix F
F.5 Grounding reference (Ground bar for the factory
environment should have a standard resistance
below 5 Ω Ω
Ω Ω Ω
)
Since ADAM-4000 / 5000 system comes with a plastic outer case with
DC power supply, its grounding procedure should be done according
to the following points:
Ø
Power supply : The E terminal of the external power supply should
be connected with the panel.
Ø
The outer case of panel should be fixed with two grounding bus.
Connect the ground of power (E-terminal) to the grounding bus
with shortest path. Use single contact for connection.
Ø
Another grounding bus is for connection with AI and AO shielded
signal wires. While AI and AO signal wires enter inside the panel,
the shielding materials is stripped off and its copper mesh should
be entangled together (There is no effect leaving alone any single
wire strand). Connect to grounding bus in the shortest path, and
then connect the two grounding buses in a way such as the
following illustration: (Please note that wire length should not be
too long, otherwise it will compromise the quality of the twisted-
pair wires)
Figure F-5 : Grounding Reference
ADAM 5000/485
T/B
DC
P/S
E
AI
AO
E
Tr
Grounding Bus
Grounding Bus
Copper mesh for Shielding
(should be grounded only on one end)
Connect to ground bar on the factory.
The ground bar should have a resistance below 5 ohm.