WARNING –
This product should be installed and serviced only by a qualified professional.
pUmp LOCATION
Locate booster pump as shown in above diagram and run suction lines as direct as possible to reduce friction
loss. Suction lines should have continuous slope upward from lowest point in line. Joints must be tight (but
not over-tightened). Suction line diameter must equal or be larger than the discharge line diameter.
Though the pump is designed for outdoor use, it is strongly advised to place pump in the shade to shield it
from continuous direct heat. Select a well-drained area that will not flood when it rains. Do NOT install pump
in a damp or non-ventilated location. Keep motor clean. Pump motors require free circulation of air for cooling.
pUmp mOUNTING
Install pump on a level concrete slab or other rigid base to meet all local and national codes. Secure pump to
base with screws or bolts to further reduce vibration and stress on pipe or hose joints. The base must be level,
rigid, and vibration free.
pump mount must:
• Allow pump inlet height to be as close to water level as possible.
• Allow use of short, direct suction pipe (to reduce friction losses) and gate valves in suction/discharge
piping.
• Be protected from excess moisture and flooding, and allow adequate access for servicing pump and
piping.
6
INSTALLATION INSTRUCTIONS
Typical Installation
Note:
Plumb the booster
pump upstream of all air
inducing equipment
From Pool
Filtration
Pump
Pool
Filter
Heater
Plumbing
Options
1, 2 or 3
Solar
System
Chlorinator
To
Spa
To
Pool
To
Cleaner
Booster
Pump
Min. of
3 feet
