Advantage Controls SFS Series, Инструкция по установке, обслуживанию и ремонту

Страница: 5 / 16

5
II. Installation
Non-Electric Model Installation
Step 1
• Remove the two screws on top
plate of solid feeder (Fig. A).
• Lift off cover and set on it’s side.
Step 2
• Clip weighted float to bottom of
wire hanger via cutout (Fig. B).
Step 3
• Insert weighted float back into
solid feeder (Fig. C).
Note: Make sure weighted float
is centered on wire hanger and
that the hanger moves freely up
and down through cap.
Step 4
• Reattach the two screws
previously removed in Step 1.
WARNING: Transporting the feeder with the weighted float attached to the
hanger can damage the hanger and cause the valve to not shut-off correctly.
Figure A
Figure B
Figure C