11
Control Module.
Manually loading numbers
1. Power ON the AdvanceMobile™ QC1 and initiate a Direct Connect (PTT)
call to it from a phone with which you want the AdvanceMobile™ QC1 to
communicate.
2. Select a channel on the Control Module
3. When the incoming call is heard on the speaker, press and hold down the
programming switch using a pen refill or similar devise. (See Diagram 8
below) The PTT button and the programming button must both be kept
depressed.
4. Successful programming of the number will be indicated by 5 short beeps
through the speaker.
5. End the call by pressing the red END button.
6. Repeat this process until all the Direct Connect (PTT) numbers with which
the AdvanceMobile™ QC1 will communicate have been loaded against the
open channel numbers of the Control Module.
Diagram 8
NOTE!
The Programming button and the Direct Connect (PTT) must be kept
depressed until the programming has been successfully made and the beeps
heard on the speaker.
Erasing numbers entered
1. To erase a number entered, power the unit and then select the channel you
want to erase on the Control Module
2. Press and hold down the programming switch as indicated above until 5
short beeps are heard on the speaker which will indicate the successful
