www.advancedco.com
5
1 Introduction
1.1 Standards
Advanced Electronics Ltd declare that the ExGo Gas Extinguishing Control Panel conforms to the essential
requirements specified in the Construction Products Directive 89/106/EEC: Refer to the full CPD schedule on
the back page.
EN12094-1:2003
EN54-2:1997 +A1:2006
EN54-4:1997 +A1:2002 +A2:2006
EN54-13:2005
In addition, the ExGo complies with the following:
Low Voltage Directive 2006/95/EC
EN60950-1: 2006
Safety of information technology equipment
Electromagnetic Compatibility Directive 2004/108/EC
EN55022: 1998
Emissions, Class B
EN50130-4: 1996 +A2: 2003
Immunity, Product Family Standard
1.2 Cautions and Warnings
STOP
BEFORE INSTALLATION – Refer To the Ratings shown on the label inside
the product and to the ‘Specifications Chart’ in this document.
Please read this manual carefully. If you are unclear on any point DO NOT
proceed. Contact the manufacturer or supplier for clarification and guidance.
Only Trained service personnel should undertake the Installation,
Programming and Maintenance of this equipment.
This product has been designed to comply with the requirements of the Low
Voltage Safety, EMC and the CPD Directives. Failure to follow the installation
instructions may compromise its adherence to these standards.
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE DEVICES
This equipment is constructed with static sensitive components. Observe anti-
static precautions at all times when handling printed circuit boards. Wear an
anti-static earth strap connected to panel enclosure earth point. Before installing
or removing any printed circuit boards remove all sources of power (mains and
battery).
1.3 Description
This manual covers the installation, programming and commissioning of the ExGo Extinguishing Control Panel.
Refer to the User Manual (Document No. 680-148) for details of how to operate the panel.
The ExGo is a Single Flooding Zone Control Panel with up to three detection zone circuits.
The detection zones are compatible with conventional detectors and call points. Refer to the compatibility
section for full details of the compatible devices tested.
Install the panel, detection circuits, sounder circuits, etc. in accordance with the instructions in Section
and then program the operation in accordance with the instructions detailed in Section
