Advanced Poly-Packaging Ti-1000, Руководство по эксплуатации, Страница: 57 / 70

head fails within 90 days
or 1,000,000 linear inches? say: <5> Ram Clear
III.
Press pause key once to say :
“No RAM clear”.
IV.
Press feed to say: Maint.Cnt.
Clear.
V.
Press pause key once to say:
Complete.
VI.
Turn power off, wait 5 seconds.
VII.
Turn power on, display will say
“On Line”.
14. Print head is locked
down, won’t come back
up. 1. Cam passed center of spring. Remove air & turn knob counter
clockwise until cam is centered on
spring, instead of forward on spring.
15. Print head goes down,
won’t print and the T1000
goes into the stop mode. No labels loaded Do we have labels loaded?
Press pause Key, to the right of the
word “pause” will be the number of
labels loaded. NOTE: If there is
nothing to the right of pause, the
down load was not accomplished.
Push the restart key and re-down
load. If nothing was excepted.
Check the software and serial cable.
16. How do you align
print head after installing
head? Poor print quality Refer to instructions on “How to
align print head”. Page 57-59 of the
Ti-1000 manual.
17. Printer does not cycle
with bagger when printer
option is “on” and labels
are loaded. H4 plug on IF board not plugged
in all the way or bad connection on
plug.
18. Print head goes down
but ribbon rollers don't
advance ribbon. Head down sensor adjusted
incorrectly. Remove air, remove large cover,
turn print head knob clockwise.
Look for the “Head Down Sensor”
LED to come on (I.F. Board). If
not, adjust sensor flag so that when
the head touches the black roller,
LED comes on. Refer to pg. 64 in
Ti-1000 manual.
19. Black platen roller has
silver shavings on it. Cam not lubricated. Remove top cover on print head
aluminum extrusion.
Clean spring and CAM under
cover and grease both the CAM and
spring, with lithium grease, replace
cover.
20. Print head goes down
intermittently. Replace IF board.
21. How do you clean
print head? Poor print quality Take a “Q” tip, and saturate it
with Isopropyl alcohol, and run “Q”
tip along white edge of the print
head until clean. Also, clean black
platen roller with alcohol and a rag.