Advanced Poly-Packaging Ti-1000, Руководство по эксплуатации

Страница: 22 / 70

Message Display / Panel Position
The Message Display / Operator Panel is either mounted inside the cover of the printer unit or provided
for remote mounting to the bagger operator panel. If shipped with the T-1000 Bagger, the panel will
already be remotely mounted in the I.O.P. for immediate operation.
2.3 Air & Power Hookup
This sections describes in detail how to hook up air and power and the air and power requirements.
Note: A qualified electrician should ensure power outlets are the required 110 - 120 VAC and properly
grounded before hooking up the power.
Air Hookup
The air supply should be fed to the Ti-1000 with 1/4 I.D. flexible tubing; this tubing affixes to the
coupler adapter. Connect the air to the regulator by holding the regulator and coupler firmly in one
hand and pushing the air line into the female fitting. After connecting air, the regulator should be
adjusted so the gauge reads 40 PSI.
Power Hookup
Insert the Ti-1000 power cord into a 110-120 VAC, 60 Hz, grounded power outlet. If shipped with the
T-1000, the printer will be connected to the power outlet located on the left rear panel of the T-1000.
2.4 Auxiliary Port Connection
The Ti-1000 connects to baggers via a 9 pin I/O port (military connector). If integrated to the
T-1000, connect the I/O aux. port to the Aux 3 port located on the rear left panel of the T-1000. (Fig 2-
1)
Note: If shipped with the T-1000, the Ti-1000 will already be connected the Aux 3 port.
(Fig 2-1)
2.5 Remote Panel Connection
The operator panel / message display is either internally mounted in the cover of the printer or remote
mounted. If remote mounted, connect the serial port connector to the printer and tighten the screws with
a small flat head screwdriver.
2.6 Main Power
The main power switch is located on the rear panel (Fig. 2-2). Press the switch to the ON position so that the Red
main power light is illuminated.
When the power is in the ON position, the Message Display panel be backlit and will display the "ON LINE"
message.
Note: If the Message Display screen does not power up to the "On Line" message, see Chapter 6, Trouble-
shooting steps.