Advanced Poly-Packaging T-200, Руководство по эксплуатации

Страница: 12 / 35

2.1 Air & Power Hookup
The T-200 is equipped with an internal regulator and the air supply should be fed to the T-200 with ¼”
min. O.D. poly tubing. Make the connection at the rear of the sealer. Set the air pressure on the T-200
between 40 and 50 psi.
2.2 Roll Mounting and Threading
Loosen one of the knobs located on the chuck which secures the roll into position. Mount the roll of bags
onto the bag roll shaft and secure the bag roll into position with the chuck. With the loose web of bags
falling over the rear of the roll, insert the web into the slot above the stainless rear cover and below the
top cover. With the web of bags positioned under the top cover, raise the top cover of the T-200 by lifting
the funnel mounting rods. Pull the web forward through the cover while lowering the top cover. When
the top cover is lowered, the first bag should open by the airflow. The roll shaft is fixed into position
with a pin and will not spin. The roll spins on the fixed shaft. See Threading Diagram at the end of the
chapter, Figure 2-1.
2.3 Main Power
The power switch is located on the rear right lower side. In the ON or “up” position, the switch is
illuminated indicating that power is supplied to the unit.
2.4 Operation / Component Test Prior to Production
Prior to beginning production, the anti-jam mechanism should be tested by following these procedures:
Test 1: With air applied and the power on, position an object over 1/4” in thickness (a pen or pencil for
example) on the far left side of the seal bar with the object in contact with the Teflon Sheet, but not
pressing in the spring-loaded “U” channel. Press the footswitch. The Anti-jam circuit is working
properly if the pressure bar retracts and immediately releases. If the pressure bar does not immediately
retract, do not begin production and refer to Chapter 3, Section 3.6 for description of Anti-jam circuit.
Test 2: With air applied and the power on, position an object over 1/4” in thickness (a pen or pencil for
example) on the far left side of the seal bar with the object pushing inward on the Teflon Sheet. Ensure
that you are pressing in the spring-loaded “U” channel Teflon Shield and then press the footswitch. The
Anti-jam circuit is working properly if the pressure bar does NOT move inward. If the pressure moves
inward, do not begin production and refer to Chapter 3, Section 3.6 for instruction on Anti-jam
Adjustments.
Continue these test procedures with the object being moved along the entire seal area length from the left
to the right side of the seal area.
2.5 Heat / Dwell Time Adjustment
The T-200 uses a heater cartridge to supply constant heat to the heater bar. The temperature controller
maintains the set sealing temperature after a minimal initial phase when the T-200 is first powered on and
the temperature will climb and then settle into the set temperature.
The duration of time that the sealer bar is against the plate can be adjusted using the two buttons marked
Seal Time and Cool Time. Tapping the Seal Time button will increase the amount of time used to create
the seal while tapping the Cool Time button will decrease the amount of time used to create the seal.
11