Advanced Poly-Packaging Advanced Poly-Bagger T-1000, Руководство по эксплуатации

Страница: 115 / 172

92
4.17
Pressure Bar (Rubber) Replacement
Located along the inside of the pressure bar is a strip of rubber, held on the pressure bar by a
channel, pressing on the edges of the rubber.
The rubber compresses against the front (gripper) plate holding the bag in place during sealing
and during bag tear off. If the rubber become brittle, torn, gouged, or otherwise worn, it should
be replaced to assure strong seals.
To replace the pressure bar rubber, simply pull
one end of the rubber from the channel. The
rubber will come out of the channel quickly
and easily.
To install a fresh piece of rubber, press one
edge of the rubber into the channel then the
other edge. Work the rubber into the channel
in small increments along the length of the
channel (Fig. 4-20).
If you used PTFE anti-stick tape to cover the
surface of the rubber, place the PTFE on the
rubber along its length. If the PTFE extends beyond Figure 4-20
the rubber, cut off the excess.
Note: PTFE may be added to the pressure bar rubber if the bag sticks to the rubber after loading
and sealing. The bag may stick to the rubber if the product and bag is light in weight and if the
rubber is dirty.
Note: Frequently clean the rubber with alcohol to remove buildup of dirt or other contaminants.
4.18
Anti-Jam Adjustment
The anti-jam device is designed to protect the T-1000 from damage when an obstruction is
encountered in the seal area (area between the pressure bar and front (gripper) plate). If properly
adjusted, the pressure bar will retract if an obstruction is encountered in the seal area.