Mode Change and Operation
Long press BACK button while
driving forward to activate
Fig. 7
y
Gain access to the back of the monitor.
y
Unplug the quad lock connector from the factory monitor and insert provided Plug and Play Quad Lock T
Harness.
y
In the Plug and Play Harness, there are two yellow RCA connectors joined together. Disconnect these and do
the following:-
h
Connect the female RCA from the vehicle side of the harness to the Male Video Output of VSW Video
Switch
h
Connect the male RCA from the vehicle side of the harness to the VSW Video 1 Input
h
The Blue/White Trigger wire is not used for this installation and should be isolated.
h
Connect the Black wire of the VSW to ground along with the Black wire from the V2P-II Interface
y
Connect the White/Red Video 2 Trigger of the VSW to the Red Switched Power wire Output of the V2P-II
Interface. When a video signal is present on the RCA this wire will output 12v.
y
Connect the Yellow 12v (+) of the V2P-II to ACC or Ignition.
y
Connect the RCA Video Output of the V2P-II to the Video 2 Input of the VSW Video Switch.
y
Connect the RCA Video cable from the caravan camera to the video female input of the V2P-II
To activate the front camera while driving forward simply long press the BACK Button on the radio for 2-3 seconds.
Please refer to the wiring diagram on the next page
(Figure 6)
for more information.
Installation Guide
